Wilson Method Past Questions
Year: 2016
School: University of Ibadan
Department: Law
Course Code: LAW102
Topics: English system of law, customary law, plagiarism, letter, memo, law library, legal academic writing, copyright infringement, legal writing
Year: 2019
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: FST532
Topics: Food sensory evaluation, sensory evaluation methods, quantitative descriptive analysis, Food sensory profile methods, Food descriptive sensory methods, Food electronic tongue sensory evaluation, Food qualitative sensory analysis, Food analytical sensory evaluation methods, facial reading techniques
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: SWE505
Topics: Agricultural land drainage, Land drainage design, surface drainage method, subsurface drainage method, parallel lateral ditch system, cross-slope ditch system, Darcy's law, Dupuit assumption, land grading, bedding method
62 Basic Organic Chemistry questions
Year: 2019
School: Nnamdi Azikiwe University
Department: Science and Technology
Course Code: ICH101
Topics: Organic Chemistry, functional group, isomerism, isomers, seperation techniques, chromatography, Carius method, Kjeldahl method
Year: 2020
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: STE401
Topics: Structural analysis, consistent deformation method, collapse moment, collapse mechanism, plastic moment capacity, fixed end moments, stiffness factor, carry-over factor, moment equation method
CHEMICAL ENGINEERING REACTION AND KINETICS
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: CHE302
Topics: method of analysis, reactor, reactant, reaction
ENGINEERING ECONOMY-2014,2016,2017,2018
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ENG212
Topics: cost, present worth method, depreciation, break-even point, interest rate, balance sheet, profit-and-loss account
REINFORCED CONCRETE DESIGN 2-2012-2018
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: STE518
Topics: column, beam, floor, shear, deflection, reinforcement, retaining wall, punching shear, yield line method, flat slab, slab, cantilever, dead load, preliminary design, bearing pressure analysis, stem wall design, stem wall reinforcement, axial load, unaxial moment, slender column
INTRODUCTION TO OPERATIONS RESEARCH
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: WRE514
Topics: linear programming, operation research, Vogel's approximation method
RELIABILITY AND QUALITY ASSURANCE IN ELECTRONICS
Year: 2018
School: Federal University of Technology, Owerri
Department: Engineering
Course Code: ECE510
Topics: reliability block diagram, fault tolerance, masking redundancy, protection method, fault analysis, quality assurance
Departments
Administration, Social and Management science
Agriculture and Veterinary Medicine
Arts and Humanities
Education
Engineering
General studies
Law
Medical, Pharmaceutical and Health science
Science and Technology